How To Find A Leak In An Above Ground Pool


Follow these steps to find out if you have a leak. The best way to identify these is by getting in the pool wearing swim goggles and closely inspecting the bottom of the pool.

How To Find & Fix A Swimming Pool Leak (Updated Jan, 2019

You find out that the leak is not within the plumbing of your pool.


How to find a leak in an above ground pool. You start looking for clues like sherlock holmes. Observe the direction of the flow of the dye in the water. This might take time, since the dye will not immediately move towards the hole or tear in your pool.

Feel the pool’s floor to see if it’s squishy, which suggests a leak in the bottom of your liner. To find the leak in your above ground pool liner: Adjust the water level in the bucket to be level with the pool.

These are the hardest leaks to find. Unfortunately short of adding food color/pool dye directly in the area of the leak you are going to have to do it the old fashioned way of diving in and inspecting the seams by hand. Signs that a swimming pool or hot tub is leaking may or may not be obvious.

If you have a leak anywhere in the pool, the water level inside the bucket will be at a level higher than that of the pool’s water. Measure the distance between the marks that you have measured every 24 hours in the pool. If both the pool and bucket lose the same amount of water, it’s evaporation.

It is quite possible the leak is a seam leak or at/below ground level. To avoid any frustration, inspect the equipment first (even if you have a feeling that the leak is inside the pool). Most above ground pools are set on top of the earth, and when there is a leak in the vinyl, the leaked water travels through the earth and leaves noticeable valleys or divots where it was once flat.

Run the filter, run the vacuum, skim the top, and brush the bottom and walls. According to , the search process involves cleaning the equipment area, inspecting the pool area for signs of wetness, turning the pump on and inspecting the skimmer and the return piping system at the wall. If you’re still convinced your pool has a leak, there is a ninja trick you can deploy, and it’s what we in the biz like to call the the bucket test.

Otherwise, a leak is indicated. When a pool leaks, the surrounding ground becomes unstable due to all the excess water. If you do see this, it’s time to get in the pool (skip to step 4).

These wet spots can occur anywhere between the pool and the equipment pad. Another common sign of a pool leak is when grassy areas surrounding the pool are abnormally damp and mushy. Ensure the pool is full (so the leak’s not above the water level).

A leak could be anywhere inside the pool, the skimmer gaskets, returning gaskets, light gaskets, and probably the stair gaskets. If you are standing near your pool and the grass feels mushy or uneven, this is a sign of an underground leak. Mark the water level of the pool at the skimmer.

You then walk around your pool to check if there are wet areas around it. Either way, these indicators determine a sense of urgency to be dealt with. Check the mark 24 hours later.

Locating these leaks requires looking at how the water flows out of the swimming pool. If you suspect a leak, there are proven ways to inspect and detect. If you suspect your pool is leaking, there are several ways to check.

The leak may be outside the pool. Sometimes pool owners mistake normal evaporation for a leak in the liner. If the distances from the pool’s marks are greater, you have a leak.

Check the skimmers, returns, cleaner line, lights, steps and the corners carefully for the source of your leak. You’re losing hope.then an imaginary light bulb appears right above your head, and you realize that the water is leaking out of the pool itself! If you do not have a habit of regularly sanitizing and clearing the equipment area, you will now have a hectic work in front of you.

Many homeowners find it so demanding to the point that they even consider replacing the entire pool liner. Your pool should lose no more than 1⁄4 inch (0.6 cm) per day. This allows you to very easily check if water is lost at the same rate.

The bucket test works by applying the same water conditions in your pool, to the water in a bucket. A clean pool with make locating the hole much easier. Wherever you suspect a leak, place a few drops of food coloring.

Most leaks are in the bottom of the pool liner, and there, the leak will usually appear as a dark spot or perhaps a small tear. Leave the bucket alone for anywhere between 3 to 7 days and do not top off the water, checking regularly to look for a change. As a result, the tiles surrounding the pool may crack or begin to move.

But with a few tips, you can avoid the hefty costs that may come with a complete replacement. The process of locating the leak might take long or fast so the best piece of advice to take is not to be in a hurry but take your time. To save you the trouble, here are 6 tips to finding a leak in an above ground pool.

If the dye flows into a certain direction, this is where the leak is coming from. If the dye seems to be stationary, it means you likely have the wrong area. Before fixing the leak you need to know how to find a leak in an above ground pool.

Continue placing food coloring around your pool until you find the leak. Position it so it's only a few inches out of the water. Run your hand from top to bottom.

Standing outside of the pool, inspect the pool’s bottom all the way around. When looking for a leak in an above ground pool, the hardest place to find it is somewhere in the vinyl liner. If the water level is considerably lower in the pool, you have a leak.

If the distances from the bucket’s marks are greater, your dog is drinking out of the bucket. Use a piece of tape or grease pencil to mark the water level. When you are trying to find a leakage spot in an above ground pool, the most difficult place will be in the vinyl liner.

Compare the recorded distances from the bucket and the pool. Next, take a slow walk around all sides of your pool. If you find gaps and cracks, it might mean a leak has been going on for a while, and the water has seeped farther outward.

Typical places where leaks occur in your pool #. If your above ground pool leaks, finding the leak may not be an easy task. First, you’ll need to thoroughly clean the pool.

Once the general area has been located, visible signs of leaking are usually the next sign we try to find.

Swimming pool leak detection How to find a leak in a pool

Ever wondered how a pool skimmer works? Click this link to

How to find a leak in an above ground swimming pool + how

Pool installation done and water going in. Backfill still

3 Ways to FixRepairPatch Intex Above Ground Pool With

How Do I Find an InGround Pool Leak? Pool Maintenance

Which Pool Type Is More Prone to Leaks? Fiberglass vs

Pool Leak Repair & Pool Leak Detection for Nassau/Suffolk

Pin on LinerWorld News & Updates

Simple Ways for Pool Leak Detection Infographics Simple

Ever wondered how a pool skimmer works? Click this link to

Backyard Pool Beach Entry Norcross, GA pool builders can

HOW TO Repair Window Leak in Coleman Swim Vista II 18ft

Incredible Stock Tank Pool Ideas with Deck Installation

How to Find a Leak in Your Swimming Pool Interesting

Pool now full. Ready for landscaping. Above Ground Pools

Pin on Brevard County, FL Pool Repair

Walls and liner going up. Pool repair, Pool service

pool divingrock Pool, Pool care, Swimming pool construction

Leave a Reply

Your email address will not be published. Required fields are marked *